The UTV I setteled on is a 2019 Polaris General EPS Deluxe with a few additions, I will get into that below...
Chaining Down
I always used to carry the utv in an enclosed trailer and hated trying to get the machine in and out when i wanted to ride. It was hard to open the doors and see to back out of the trailer, also tying the machine down was not good. I would have to strap down the machine and that would compress the suspension, so I solved that with this setup...
You can see below, I use binders and chains that are not only much stronger but are lower to the trailer so rather than pulling down, they are mostly pulling from front to back and vise versa. Works fantastic! To Attach to the UTV itself i have a fabric based load rated solution so it does not scratch my rock gaurds.
Chains and binders.
UTV Is protected by the camper in front.
Used to have lighted whips, since taken them off.
Some Accessories I have installed are...
Ryfab Tonneau cover
Ryfab Bumpers
Mud flaps
Whinch
Polaris radio
overhead light
Check out my other articles about setups by searching or browsing.
